ADLINK Technology cPCI-8210 Manual de usuario descargar pdf (Pagina 16)

8 • Installation & Configuration

2.2 Connect the Network Cable

Category 5 UTP cable qualifies for both, the Fast Ethernet And Ethernet,

cabling rules. The maximum length of any single cable run between any

station and its supporting Hub is 100 meter .The maximum length of a cable

joining two hubs is 10m in general, but is 100m when both hubs qualify as

Ethernet class 2 Repearters. However, these cable runs may need to be

shorter than the given individual maximum lengths because their maximum

aggregated cable run between any two stations is 205m.

Connecting for 100Mbps Ethernet

Category 5 UTP cable is required for fast Ethernet operation. The maximum

cable run between the cPCI-8211 and the supporting hub is 100 meters.

The cable must be straight (not a crossover cable) with an RJ-45 plug at

each end. Make the network connection by plugging one end of the cable

into the RJ-45 jack of the cPCI-8211, and the other end into a port of the

supporting hub.

Connecting for 10Mbps Ethernet

Category 3, Category 4, and Category 5 UTP cable, as well as EIA/TIA-568

100-0hm STP cable, all qualify under Ethernet cabling rules. The maximum

cable run between the cPCI-8211 and the supporting hub is 100 meters.

The cable must be straight (not a crossover cable) with RJ-45 connector at

each end. Make the network connection by plugging one end of the cable

into the RJ-45 jack of the cPCI-8211, and the other end into a port of the

supporting Hub.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 32 33

Sin comentarios

ADLINK Technology cPCI-8210 Manual de usuario Pagina 16